Fitting Guide

Feature wall art vinyl fitting guide

Application img.1


1: Application tape

2: Backing paper

3: Vinyl decal


Along with each item we offer an application squeegee.

Please Note: you only need one of these per order, they will last a long time and you will be able to install a lot of wall art's with this one squeegee.

 Leave new paint a minimum of 2-3 weeks to dry properly (longer in winter/ damp periods)

 

Installation for small decals.

Installation Image for small decals

 

1: Line the decal up on the wall in the required position and hold in place with masking tape, use a squeegee or credit card, to rub and remove all air bubbles.

2: Lift up the decal from the bottom and proceed slowly to pull back the backing paper, leaving the decal attached to the application tape. If the decal remains attached to the backing paper, simply push the backing paper back and rub over the application tape again.

3: Slowly rub the squeegee over the top of the application paper, to apply the decal to the wall whilst removing the backing paper.

4: Once the backing paper is removed, continue to rub the decal on to the wall, ensuring all bubbles are removed.

5: Slowly proceed to peel back the application tape, if the decal comes off with the application tape, simply push back and rub again.

6: Stand back and admire your work.

 

Installation for larger decals.

 

Installation Image for large decals

 

1: Line the decal up on the wall in the required position and hold in place with masking tape.

2: Run a length of masking tape across the top edge to act as a hinge, then use a squeegee or credit card to rub and remove all air bubbles.

3: Using scissors carefully cut the decal in between the words, to provide manageable sections

4: Lift up the decal from the bottom and proceed slowly to pull back the backing paper, leaving the decal attached to the application tape. If the decal remains attached to the backing paper, simply push the backing paper back and rub over the application tape again.

5: Slowly start to rub the squeegee over the top of the application paper, to apply the decal to the wall whilst removing the backing paper. Once the backing paper is removed, continue to rub the decal on to the wall, ensuring all bubbles are removed.

6: Slowly proceed to peel back the application tape, if the decal comes off with the application tape, simply push back and rub again.

7: Repeat from step 3 above until complete

8: Stand back and admire your work.

 

 

Removing Wall Art.

If you fancy a change and would like to remove your wall art,

simply peal off the wall, you may use a hairdryer to warm up the vinyl to aid the removal.


Feature Wall Art will not be responsible if you install your stickers on a damp wall and they begin to peel away.